Kia Rio: Parking brake - Maintenance - Kia Rio UB 2012-2024 Owners ManualKia Rio: Parking brake

Checking the parking brake


Checking the parking brake

Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alone should securely hold the vehicle on a fairly steep grade. If the stroke is more or less than specified, have the parking brake adjusted by an authorized Kia dealer.

Stroke : 6~8 “clicks’’ at a force of 44 lbs (20 kg, 196 N).

Air cleaner

Filter replacement


Filter replacement

It must be replaced when necessary, and should not be washed.

You can clean the filter when inspecting the air cleaner element.

Clean the filter by using compressed air.

1. Loosen the air cleaner cover attaching clips and open the cover.


1. Loosen the air cleaner cover attaching clips and open the cover.

2. Wipe the inside of the air cleaner.


2. Wipe the inside of the air cleaner.

3. Replace the air cleaner filter.

4. Lock the cover with the cover attaching clips.

Replace the filter according to the Maintenance Schedule.

If the vehicle is operated in extremely dusty or sandy areas, replace the element more often than the usual recommended intervals. (Refer to “Maintenance under severe usage conditions” in this section.)

CAUTION - Air filter maintenance

Washer fluid
Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer sol ...

Climate control air filter
Filter inspection The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a ...

See also:

Smart key unit Removal
Smart key unit [USA] 1. Disconnect the negative(-) battery terminal. 2. Remove the smart key unit (A) after disconnecting the c ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Specification
HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) ...

Copyright © www.kirmanual.com 2014-2024