1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the power window switch module.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
[Standard]
[Power Mirror Switch - With Folding Mirror]
[Power Mirror Switch - Without Folding Mirror]
|
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Water pump: Troubleshooting
Water Pump
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
...