Kia Rio: Front Washer Motor Inspection
| Front Washer Motor |
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
| 3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
| 4. |
If they are abnormal, replace the washer motor.
Connector No.1 : Windshield washer(+)
2 : Ground
|
Front & Rear Washer Motor
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
| 3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
| 4. |
If they are abnormal, replace the washer motor.
Connector No.1 : Windshield washer(+)
2 : Ground
3 : Rear washer (+)
|
Front Wiper Motor Inspection
Speed Operation Check
1.
Remove the connector (A) from the wiper motor.
1. -
2. IGN+
3. Parking
4. High
5. GND
6. Low
...
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
See also:
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
...
Intake Manifold: Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
Tightening torque :
With ...
Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine
modifications and the addition of special control components.
Modifications to the combustion chamber, intake manifo ...
Categories
- Kia Rio Manuals Home
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright © www.kirmanual.com 2014-2025