Kia Rio: Sunroof Switch Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Using a screwdriver or remover, remove the overhead console cover (A).

3.	After loosening the mounting screws, then remove the overhead console assembly (A).

4.

Check for continuity between the terminals. If the continuity is not as specified, replace the sunroof switch.

1. Ground
2. Switch A

3. Switch B
4. Switch C

Circuit Diagram

...

Sunroof Motor Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - " Roof trim") ...

See also:

Hood switch Description
The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or stopped by the ISG function for safety re ...

Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

System Circuit Diagram
MDPS Circuit Diagram Harness Connector Connector Pin no Pin name Descrption Specifcation TAS sensor signal 8P connector A 1 ...

Categories

Copyright © www.kirmanual.com 2014-2025