Kia Rio: Compressor Installation - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2025 Service ManualKia Rio: Compressor Installation

1.
Make sure of the length of compressor mounting bolts, and then tighten it with the specified tightening order.

Tightening torque :
22~33 N.m (2.04~3.36 kgf.m, 14.8~24.3 lb-ft)


2.
Install in the reverse order of removal.
A.
If you install a new compressor, drain all the refrigerant oil from the removed compressor and measure its volume. Subtract the volume of drained oil from the original compressor oil capacity (120 cc). The result is the amount of oil you should drain from the new compressor (through the suction fitting)
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
D.
Immediately after using the oil, replace the cap on the container and seal it to avoid moisture absorption.
Compressor Removal
1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. ...

Compressor Inspection
1. Check the plated parts of the disc & hub assembly (A) for color changes, peeling or other damage. If there is damage, replace the clutch set. ...

See also:

Troubleshooting
1. The lamp switch inputs can be checked using the GDS. 2. To check the input value of lamp switch, select option "Body Control Module ...

Intake Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to BD group - "Crash Pad") ...

Description
The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Acc ...

Copyright © www.kirmanual.com 2014-2025