Kia Rio: Auto Defogging Sensor (FATC only) Replacement
| 1. |
Remove the auto defogging sensor cover (A).
|
| 2. |
Disconnect the connector (B) and then remove the auto defogging
sensor (C).
|
| 3. |
Install in the reverse order of removal.
|
Auto Defogging Sensor (FATC only) Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
Display
Fail description
00 ...
Cluster Ionizer (FATC only) Description
The cluster ionizer helps to clean up odors in the vehicle or from the
air-conditioner system.
When the ignition switch ON, the inoizer runs a "CLEAN" mode and then
a "ION& ...
See also:
Rear Door Components
1 . Rear door trim
2 . Rear door trim seal
3 . Rear door panel
4 . Rear door belt inside weatherstrip
5 . Rear door belt outside weatherstrip
6 . Rear door delta lower ...
Installation
•
Install the component with the specified torques.
•
...
Exhaust Manifold: Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
Tightening torque :
Witho ...
Copyright © www.kirmanual.com 2014-2024