Kia Rio: Blower Unit Replacement
| 1. |
Remove the heater & blower unit.
(Refer to HA group - "Heater Unit")
|
| 2. |
Separate the blower unit from the heater unit after loosening
the screws.
|
| 3. |
Install in the reverse order of removal.
|
Blower Unit Components
1. Blower Motor
2. Blower Fan
3. Clamp
4. NVH Pad
5. Connection Case
6. Cluster Ionizer (FATC only)
7. Intake Case (Left)
8. Intake Seal
9. NVH Pad
10. Intake ...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...
See also:
SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
▷ Control type : Normal low type
Control pressure kpa (kgf/cm², psi)
490.33(5.0, 71.12)
Internal resistance(&# ...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of the F ...
Copyright © www.kirmanual.com 2014-2024