Kia Rio Manuals

Kia Rio: Adjustment - Clutch Release Cylinder - Clutch System - Kia Rio UB 2012-2025 Service ManualKia Rio: Adjustment

Clutch Release Cylinder Air Bleeding Procedure

     
Use the specified fluid. Avoid mixing different brands of fluid.
Specified fluid: SAE J1703 (DOT 3 or DOT 4)
1.
After disconnecting a cap from the clutch release cylinder air bleeder, insert a vinyl hose in the plug.
2.
Loosening the plug screw, press and release the clutch pedal about 10 times.
3.
Tighten the plug (A) during the clutch pedal pressed. Afterwards, raise the pedal with a hand.
4.
After pressing the clutch pedal 3 times more, loosen the plug (A) and retighten it with the pedal pressed. Raise it again, then.
5.
Repeat the step 4 two or three times. (until there is no bubble in the fluid)
Tightening torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 9.2 ~ 13.3 lb-ft)


6.
Refill the clutch master cylinder with the specified fluid.
Installation
1. Installation is the reverse of removal.    Coat the clutch clevis push r ...

Manual Transaxle System
...

See also:

Output Speed Sensor Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Schematic Diagram
Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PC ...

Component(1)
※ Installation order : A → B → C → D → E 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. Screw 5. Steering angle ...

Categories


Copyright © www.kirmanual.com 2014-2025