Kia Rio: 26 Brake Control Solenoid Valve(26/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
26 Brake Control Solenoid Valve(26/B_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Line Pressure Control Solenoid Valve Description
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
See also:
AGM Battery: Specification
Item
Specification
Model type
AGM 70L-DIN
Capacity [20HR/5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
...
Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Electric Oil Pump: Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the
input shaft to generates oil pressure when input shaft rotates.
But, this transaxle equipped with ISG system also has ...
Copyright © www.kirmanual.com 2014-2024