Kia Rio: 35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

35R Clutch Control Solenoid Valve(35R/C_VFS) Circuit Diagram

...

35R Clutch Control Solenoid Valve(35R/C_VFS) Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Input Speed Sensor Circuit Diagram
...

Radiator: Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, then install it to pressure tester. 2. Apply ...

TPMS Sensor Installation
Sensor Fit • Handle the sensor with care. • ...

Categories

Copyright © www.kirmanual.com 2014-2025