Kia Rio: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
See also:
Inspection
Rear Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad.
(Refer to BD group - "Crash Pad")
...
Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Copyright © www.kirmanual.com 2014-2024