Kia Rio: Shift Lever Adjustment
| Adjusting the control cable |
| 1. |
Set room side AT lever(shift lever) and automatic transaxle side
manual control lever to "N" position.
|
| 2. |
Connect control cable to room side AT lever(shift lever).
|
| 3. |
Fix temporary control cable (A) in automatic transaxle side manual
control lever.
|
| 4. |
Push the control cable (A) lightly to "F" direction shown to eliminate
the free play.
|
| 5. |
Tighten the adjusting nut (B).
|
| 6. |
After adjusting, check that this part operates at each range of
the manual control lever corresponding to each position of the AT lever(shift
lever).
|
| Adjusting Procedure For Lock Cam And Shift Lock Cable |
| 1. |
Shift lock cable must be fixed to brake pedal(brake pedal must
not be pressed down), and at lever(shift lever) must be "N" position
|
| 2. |
Shift lock cable must be assembled to at lever(shift lever) assembly
as shown in fig. 1. cable end must be inserted into fixing pin (A) of
lock cam securely.
|
| 3. |
Maintain close adhesion lock cam (E) and lock cam stopper (D)
slightly pull outer casing of shift lock cable (E) in direction "E"
to remove slack of shift lock cable (E).
|
| 4. |
After checking that cable end is touched to cable fixing pin of
lock cam, fix adjust plate.
|
| 5. |
Check that cable end (B) is touched to cable fixing pin of lock
cam (A).
|
| Checking List Of Shift Lock |
| 1. |
Brake pedal being not depressed.
AT lever (shift lever) must not be shifted from "P" position to
"R" posion.
|
| 2. |
Brake pedal being not depressed.
AT lever (shift lever) must not be shifted from "N" position to
"R" posion.
|
| 3. |
Brake pedal being deprseeed by stroke 15-26mm in "P" position.
Push button can be operated and AT lever (shift lever) can be
shifted smoothly from each position to other positions.
|
| 4. |
Brake pedal must be operated smoothly without interruption at
all positions.
|
Shift Lever Removal
Shift Lever Assembly Replacement
1.
Remove the center console.
(Refer to "interior (console)" in BD group)
2.
Di ...
See also:
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
...
BCM Overview
The Body Control Module (A) supplies vehicle occupants with visual and
audible information and controls various vehicle functions.
To provide and receive information, the module is interface ...
Hands free switch Schematic Diagrams
Circuit Diagram(1)
Circuit Diagram(2)
...
Copyright © www.kirmanual.com 2014-2025