Kia Rio: Front Strut Assembly Inspection
| 1. |
Check the components for damage or deformation.
|
| 2. |
Compress and extend the piston rod (A) and check that there is
no abnormal resistance or unusual sound during operation.
|
Front Strut Assembly Disassembly and Reassembly
1.
Compress the coil spring with a strut spring compressor. Do not
compress the spring more than necessary.
2.
Loosen the lock nut.
...
Front Lower Arm Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge control solen ...
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Copyright © www.kirmanual.com 2014-2024