Kia Rio: Shift Lever Adjustment - Manual Transaxle Components - Manual Transaxle System - Kia Rio UB 2012-2025 Service ManualKia Rio: Shift Lever Adjustment

1.
In neutral position, disjoin select cable (A) from shift lever assembly pin (B).


2.
Disconnect select adjuster (A) to an arrow.


3.
Shift to the 3th gear position.
4.
Adjustment adjuster (B) on select cable (A) as rolling from side to side.


5.
Insert on free load and press the adjuster.
6.
After shifting 2nd gear, cheking the left select gap about 1mm(if not, loop no, 1~5)

     
If there are still gate blocking in spite of re-adjustment, shift lever assembly stopper stoke must be cheked.
7.
In neutral position, jion by clip (A).


Shift Lever Inspection
1. Check the select cable for proper operation and for damage. 2. Check the shift cable for proper operation and for damage. ...

Back-up Lamp Switch Description
Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

See also:

Disassembly
Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. M/T : Remove the fly wheel. 2. ...

Alternator: Removal and installation
1. Disconnect the battery negative terminal first, then the positive terminal. Tightening torque (+) terminal : 7 ...

Ignition Coil: Inspection
1. Measure the primary coil resistance between terminals (+) and (-). Standard value: 0.75Ω ± 15% ...

Copyright © www.kirmanual.com 2014-2025