Kia Rio: Specifications
| Items |
Specifications |
|
| Rated voltage |
DC 12V |
|
| Operating temperature range |
-30°C ~ +80°C (-22 ~ +176°F) |
|
| Rated load |
Dimmer and passing switch |
High : 1A (Lamp load) Low : 1A (Lamp load) Passing : 1A (Lamp load) |
| Lighting switch |
1A (Lamp load) |
|
| Turn signal & lane change switch |
6.6 ± 0.5A (Lamp load) |
|
| Front & rear fog lamp switch |
1A (Relay load) |
|
| Wiper & mist switch |
Mist, Low, High : 4A (Motor load) Intermittent : 0.22 ± 0.05 A (Relay load) Lock : 28 A (Motor load) |
|
| Front & Rear washer switch |
5 A (Motor load) |
|
| Variable intermittent volume switch (Rain Sensor) |
Max. 25 mA |
|
| Rear wiper switch |
0.2A (Relay load) |
|
Component(1)
※ Installation order : A → B → C → D → E
1. Steering column shaft
2. Lighting switch
3. Wiper and washer switch
4. Screw
5. Steering angle ...
See also:
ISG (Idle stop and go) system
Your vehicle may be equipped with the ISG system, which reduces fuel consumption
by automatically shutting down the engine, when the vehicle is at a standstill.
(For example : red light, stop sign ...
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
Components Operations
ECM (Engine Control Module)
1.
The ECM(PCM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transponder
...
Copyright © www.kirmanual.com 2014-2024