If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console.
The sunroof can only be opened, closed, or tilted when the ignition switch is in the ON position.
In cold and wet climates, the sunroof may not work properly due to freezing conditions.
After the vehicle is washed or in a rainstorm, be sure to wipe off any water that is on the sunroof before operating it.
CAUTION - Sunroof control lever
Do not continue to press the sunroof control lever after the sunroof is fully opened, closed, or tilted. Damage to the motor or system components could occur.
The sunroof cannot slide when it is in the tilt position nor can it be tilted while in an open or slide position.
Sliding the sunroof
To open the sunroof, pull the sunroof control lever backward.
To close the sunroof, push the sunroof control lever forward.
To open the sunroof automatically:
Pull the sunroof control lever backward to the second detent position and then release it. The sunroof will slide all the way open.
To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.
To close the sunroof automatically:
Push the sunroof control lever forward to the second detent position and then release it. The sunroof will automatically close all the way.
To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.
While driving with the sunroof in an open (or partially open position), your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening
Automatic reversal
If an object or part of the body is detected while the sunroof is closing automatically, it will reverse direction, and then stop.
The auto reverse function does not work if a tiny obstacle is between the sliding glass and the sunroof sash. You should always check that all passengers and objects are away from the sunroof before closing it.
Input Speed Sensor Installation
1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of ...
Radiator: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal (without battery sensor):
7.8 ~ 9.8N.m (0.8 ~ 1.0 ...
Oil Pump Unit (OPU) Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the crash pad lower panel. (Refer to “Crash pad” in BD
group.)
...