Kia Rio: Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor converts the pressure to voltage signal. By using
this signal, the ECM can control correct injection amount and timing and adjusts
the fuel pressure with the fuel pressure regulator valve if the target pressure
and the actual pressure calculated by the RPS output signal are different.
Specification
...
See also:
Rear Seat Belt Replacement
Rear Seat Belt Replacement
[5 Door]
•
When installing the belt, make sure not ...
TJ Joint Components
[LH]
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Shaft
6. TJ boot band
7. TJ boot
8. Spider assembly
9. Snap ring
10. TJ c ...
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Parking ...
Copyright © www.kirmanual.com 2014-2024