Kia Rio: Auto Light Sensor Removal

Auto Light Sensor Inspection

In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor ...

Auto Light Sensor Installation

1. Reconnect the auto light connector. 2. Install the auto light sensor. ...

See also:

Engine overheat
If your temperature gauge indicates overheating, you will experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1.Pull off the ...

Positive Crankcase Ventilation (PCV) Valve: Removal
1. Disconnect the vapor hose (A) after removing the fixing clip. 2. Remove the PCV valve (B) after unfastening it. ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to the ...