Kia Rio: Inspection
| 1. |
Inspect diaphragm spring wear which is in contact with a concentric
slave cylinder bearing.
|
| 2. |
Check the clutch cover and disc surface for wear or cracks.
|
| 3. |
Check the clutch disc lining for slipping or oil marks.
|
| 4. |
Measure the depth from a clutch lining surface to a rivet. If
the measured value is less than the specification below, replace it.
|
Removal
1.
Remove the transaxle assembly.
(Refer to "Manual transaxle system" in MT group)
2.
Remove the clutch cover bolts. Be care ...
Installation
1.
Replace a clutch cover and disc as a set.
•
...
See also:
Installation
•
Install the component with the specified torques.
•
...
Rear Coil Spring Replacement
1.
Remove the rear wheel & tire.
(Both RH side and LH side)
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...
BJ Boot Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
Copyright © www.kirmanual.com 2014-2024