Kia Rio: Side Impact Sensor (SIS) Installation
| Pressure Side Impact Sensor |
|
1. |
Install the new pressure side impact sensor with the screws (B)
then connect the pressure side impact sensor connector (A).
Tightening torque :
2.5 ~ 3.5 N.m (0.25 ~ 0.36 kgf.m, 1.8 ~ 2.6 lb-ft)
|
|
• |
Use the specified screws.
|
|
|
|
2. |
Install the front door trim.
(Refer to the Body group - "Front door")
|
|
3. |
Reconnect the battery negative cable.
|
|
4. |
After installing the pressure side impact sensor, confirm proper
system operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
• |
You must comply with the specified tightening
torques with the tool specified because Pressure – Side
Impact Sensors (P-SIS) may be broken or POP-NUT may
be rotated.
|
|
• |
Problems may occur in the durability of P-SIS
or the impact sensing performance may depreciat if POP-NUT
is rotated.
|
|
• |
The door module must not be modified because SRSCM
judges an impact through the pressure sensor in the
door module.
|
|
|
Side Impact Sensor
| •
|
Do not turn the ignition switch ON and do not connect
the battery cable while replacing the side impact sensor.
|
|
|
1. |
Install the new side impact sensor (B) with the bolt and then
connect the side impact sensor connector (A).
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
|
2. |
Install the center pillar trim.
(Refer to the Body group - "Interior tirm")
|
|
3. |
Install the door scuff trim.
(Refer to the Body group - "Interior tirm")
|
|
4. |
Reconnect the battery negative cable.
|
|
5. |
After installing the Side Impact Sensor, confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
Pressure Side Impact Sensor
•
Removal of the airbag must be performed according to ...
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The se ...
Side Impact Sensor (SIS) Removal
Seat Belt Buckle Switch (BS) Description