Kia Rio: Audio Remote Control Inspection

1.

Check the audio remote control switch (A) for resistance between No.5 and No.7 terminals in each switch position.

Switch	Connector terminal	Resistance (± 5%)
SEEK UP	6-7 (LH)	430 Ω
SEEK DOWN	6-7 (LH)	1.11 kΩ
MODE	6-7 (LH)	2.11 kΩ
MUTE	6-7 (LH)	3.11 kΩ
VOLUME UP	6-7 (LH)	4.61 kΩ
VOLUME DOWN	6-7 (LH)	6.81 kΩ
CANCEL	3-4 (RH)	180 Ω
SET -	3-4 (RH)	330 Ω
RES +	3-4 (RH)	550 Ω
ON/ OFF	3-4 (RH)	880 Ω
SLD	3-4 (RH)	1.44 kΩ
VOICE	3-4 (RH)	10.71 kΩ

Switch	Connector terminal	Resistance (± 5%)
END	5-6 (Lower LH)	18.91 kΩ
SEND	5-6 (Lower LH)	40.91 kΩ
TRIP	5-6 (Lower RH)	2.54 kΩ
RESET	5-6 (Lower RH)	5.54 kΩ

Audio Remote Control Schematic Diagrams

Circuit Diagram (1) Circuit Diagram (2) ...

Audio Remote Control Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group - "DAB and Clock spring ...

See also:

Hood switch Description
The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or stopped by the ISG function for safety re ...

Fluid Replacement
ATF of 6 speed automatic transaxle doesn’t need to be replaced. If the vehicle is used severely in business or personal ...

Front Impact Sensor (FIS) Removal
• Removal of the airbag must be performed according to the precautions/ procedures descr ...

Categories

Copyright © www.kirmanual.com 2014-2024