Kia Rio: ISG (Idle Stop & Go) System

Installation

   • Install the component with the specified torques. • ...

Description

Idle Stop & Go (ISG) function automatically switches off the engine when the car is at a standstill if the and starts it again as soon as the brake pedal is released. This not only reduce ...

See also:

Transaxle Control Module (TCM) Terminal Function
Connector [EGGG-AA] Pin Description Pin Description 22 Shift solenoid D (VFS-OD) 73 Inhibitor switch signal "S4" ...

Oil Pump Description
The oil pump is built-in as a single unit with the 26 brake chamber. Rotation of the pump builds the hydraulic pressure needed for the lubrication of the various parts of the transaxle and op ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...